Waterlogic UV lamp

The Waterlogic UV lamps are used inside your water cooler as an extra protection against bacteria, purifying your water. The UV lamp can be accessed through the top half of your water cooler. When your UV lamp fails and your cooler signals UV fault simply replace the lamp.

• For WL2500 tabletop use 4 watt UV lamp (PN 011221)
• For WL2500 freestanding use 8 watt UV lamp (PN 006162)
• For Waterlogic 4 use 11 watt UV lamp (PN 16409954)

Instalation
installation is relitivly simple.

1. Power down your water cooler. (Remove plug from wall)
2. Remove lid from water cooler. (This can be done by removing all relevant screws)
3. Locate UV lamp and dissconnect from water cooler.
4. Pull UV lamp out of Quarts sleeve and remove looming. (if your UV lamp is wet you may have a broken Quarts sleeve (the tube in which your UV lamp sits) and will need replacing) .
5. Check looming for damage. (if damaged it will need replacing)
6. Attach looming onto new UV lamp and place back into Quarts sleeve.
7. Connect the UV lamp back up to the water cooler.
8. Replace Water cooler lid and power up.

For further assistance please call: 0161 775 5691

Write a review