Waterlogic UV Looming

The Waterlogic UV looming is used to connect the UV lamp to the water cooler. The UV looming can be accessed through the top half of your water cooler. When your UV lamp fails and your cooler signals UV fault, the general cause is the lamp itself, but can be a number of things including a broken UV looming.

• For WL2500 tabletop use small looming (PN 105675)
• For WL2500 freestanding use large UV looming (PN 006174)

installation
installation is relitivly simple.

• Power down your water cooler. (Remove plug from wall)
• Remove lid from water cooler. (This can be done by removing all relevant screws)
• Locate UV lamp and dissconnect from water cooler
• Pull UV lamp out of Quarts sleeve and remove looming. (if your UV lamp is wet you may have a broken Quarts sleeve (the tube in which your UV lamp sits) and will need replacing) 
• Attach new looming onto UV lamp and place back into Quarts sleeve.
• Connect the UV lamp back up to the water cooler.
• Replace Water cooler lid and power up.

for further assistance please call: 0161 775 5691

Write a review